Driven Sprocket Support Assembly Installation

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Driven Sprocket Support And 2nd Clutch Assembly

Courtesy of GENERAL MOTORS CORP.

Install the driven sprocket support and 2nd clutch assembly (95) into the transaxle case (51). When installed properly, the driven sprocket support sits slightly below the machined surface of the transaxle case (51).