Drive, Driven Sprockets and Drive Link Assemble

Tools Required

• J 29569-1  Turbine Shaft Seal Installer. See Special Tools and Equipment .
• J 29569-2  Turbine Shaft Seal Sizer. See Special Tools and Equipment .
• J 29829-1  Turbine Shaft Seal Installer. See Special Tools and Equipment .
• J 29829-2  Turbine Shaft Seal Sizer. See Special Tools and Equipment .

Fig 1: Expanded View Of Drive Sprocket & Snap Rings
Courtesy of GENERAL MOTORS CORP.
1. Assemble the drive sprocket (37) onto the turbine shaft (39).
2. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).
Fig 2: Installing Seals On Turbine Shaft
Courtesy of GENERAL MOTORS CORP.
3. In order to assemble three new Teflon seals (33, 40) onto the turbine shaft (39), perform the following procedure:
   1. Slide the J 29569-1  over the large spline of the turbine shaft.
   2. Coat the J 29569-1  with transmission fluid.
   3. Use your fingers in order to guide the new Teflon™ seals over theJ 29569-1  and into the seal ring grooves on the turbine shaft.
   4. Remove the J 29569-1  when the seals are in place.
   5. Size the new Teflon™ seals. Use both halves of the J 29569-2  .
   6. In order to properly size the seals, keep the J 29569-2  in place for five minutes.
   7. Repeat steps 3.1 thru 3.6 with J 29829-1  and J 29829-2  on the small splined side of the turbine shaft.