LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Automatic Transaxle - 4T40-E/4T45-E - Overhaul) >> Repair Instructions >> Drive Sprocket, Driven Sprocket, and Drive Link Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Sprocket, Driven Sprocket, and Drive Link
    GM20183Courtesy of GENERAL MOTORS CORP.
  1. Install the drive sprocket to drive sprocket support thrust washer (38) to the drive sprocket (37). Place the tabs on the thrust washer into the holes on the drive sprocket.
  2. Retain the thrust washer with J 36850  or equivalent.
  3. Install the driven sprocket to driven sprocket support thrust washer (92) onto the driven sprocket support (95).
    4. IMPORTANT: Orient the drive link assembly (36) in the same direction in which the drive link assembly (36) was removed. If the drive link assembly (36) is new, you can install it in either direction.
  4. Install the drive link assembly (36) to the drive and driven sprockets (37 and 91).
  5. Install as a complete assembly, the drive sprocket (37) the driven sprocket (91), and the drive link assembly (36) onto the transmission.
scientia non olet · About LEMON Manuals