Drive Sprocket Support Assemble

WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 23327 Clutch Spring Compressor. See Special Tools and Equipment .
J 41232 Return Spring Compressor. See Special Tools and Equipment .

Fig 1: Identifying 2nd Clutch Piston And Seal Assembly

Courtesy of GENERAL MOTORS CORP.

In order to aid in the assembly, lubricate the seal with transmission fluid.
Assemble the 2nd clutch piston and seal assembly (404) into the driven sprocket support (401).
Assemble the 2nd clutch spring and retainer assembly (405) into the driven sprocket support.

Fig 2: View Of 2nd Clutch Spring Retainer Snap Ring

Courtesy of GENERAL MOTORS CORP.

Compress the 2nd clutch spring assembly. Use the J 41232 and J 23327 .
Assemble the 2nd clutch spring retainer snap ring (406).
Remove the J 41232 and J 23327 .

Fig 3: Locating Seal Rings On Driven Sprocket Support

Courtesy of GENERAL MOTORS CORP.

Assemble two new seal rings (403) onto the driven sprocket support.