Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire, 2004 Chevrolet Classic, and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the channel plate to drive sprocket thrust washer (34) onto the channel plate (27).
- Retain the thrust washer (34) with J 36850 or equivalent.
- Install a new channel plate to case gasket (28) onto the transmission case (51).
- Install the channel plate assembly onto the transmission case (51). The channel plate should fit tightly over the guide pins (45) located on the transmission case (51).
- Install the two channel plate to driven sprocket support bolts (25).
Tighten: Tighten the two channel plate to driven sprocket bolts (25) to 14 N.m (10.5 lb ft).
- Install the six channel plate to case bolts (25). Hand tighten the bolts.
Tighten: Tighten the six channel plate to case bolts and the two channel plate to driven sprocket support bolts to 12 N.m (9 lb ft).
- Install the two channel plate to case bolts (8). Hand tighten bolts.
Tighten: Tighten the two channel plate to case bolts (8) to 14 N.m (10.5 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.