LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the clutch pedal and bracket assembly.
    Fig 1: Identifying Clutch Pedal And Bracket Assembly
    GM100718Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the clutch pedal and bracket mounting nuts.

    Tighten:  Start with the lower nuts, tighten the nuts to 21 N.m (15 lb ft).

    Fig 2: Locating Clutch Pedal Bracket Mounting Nuts
    GM100713Courtesy of GENERAL MOTORS CORP.
  3. Install the instrument support bracket bolt.
  4. Install the instrument panel support beam.
  5. Install the clutch master cylinder pushrod bushing on the pedal. Lubricate the bushing.
  6. Install the clutch master cylinder pushrod to the clutch pedal.
  7. Install the cruise control switch.
  8. Connect the following components:
    • The cruise control switch
    • The clutch position switch
scientia non olet · About LEMON Manuals