LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new stud from the back side of the hub.
  2. Install the four flat washers (3) on the hub.
  3. Install the wheel nut with the flat side toward the washers.
  4. Tighten the nut until the stud is properly seated in the hub flange.
    Fig 1: Installing Wheel Stud
    GM165253Courtesy of GENERAL MOTORS CORP.
  5. Remove the nut and the washers.
  6. Install the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
  7. Install the tire and the wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals