LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber (5) to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the shock absorber lower mounting bolt (4).

    Tighten:  Tighten the bolt to 70 N.m (51 lb ft).

  3. Raise the rear axle with a jackstand until the shock absorber (5) is in position to install the upper mounting bolts (2).
  4. Install the shock absorber upper mounting bolts (2).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  5. Remove the jackstand and lower the vehicle.
  6. Install the shock absorber upper mounting nut (1).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    Fig 1: Identifying Shock Absorber Upper Mounting Nut & Bolt
    GM165258Courtesy of GENERAL MOTORS CORP.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Replace the rear compartment carpet to the original position.
scientia non olet · About LEMON Manuals