Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Remove the brake drum. Refer to Brake Drum Replacement .
NOTE: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.
Remove the adjuster spring. Disengage the adjuster spring hook end from the tab on the adjuster actuator lever, then release the spring from the brake shoe web hole.

Fig 1: Identifying Brake Shoe Adjuster Spring
Courtesy of GENERAL MOTORS CORP.
Remove the adjuster actuator lever from the pivot.

Fig 2: Identifying Brake Shoe Adjuster Actuator Lever
Courtesy of GENERAL MOTORS CORP.
Using the J 38400 (1), spread the top of the brake shoes apart and remove the adjuster assembly (2).

Fig 3: Removing/Installing Brake Shoe Adjuster Assembly Using Special Tool
Courtesy of GENERAL MOTORS CORP.
Inspect the adjuster assembly for the following conditions:
- Binding or seized threaded adjuster assembly.
- Damaged or missing adjuster screw teeth.
Replace the adjuster assembly if any of the conditions listed are present.