LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and dry the vehicle speed sensor.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the vehicle speed sensor and the retaining stud.

    Tighten:  Tighten the stud to 12 N.m (97 lb in).

    Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud
    GM104524Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector at the sensor.
  4. Lower the vehicle.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals