LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Transmission Fluid Pressure (TFP) Manual Valve Position Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TFP switch assembly to the control valve body assembly. The seven pressure switch O-rings are reusable and should remain with the TFP switch assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the six bolts to the TFP switch assembly.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

  3. Install the transmission side cover. Refer to Case Side Cover Replacement .
    Fig 1: Locating Transmission Fluid Pressure (TFP) Manual Valve Position Switch
    GM893159Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals