LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Park/Neutral Position (PNP) Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake and place the control assembly in Neutral. The transaxle manual shaft must be in the Neutral position prior to installing the range switch.
  2. Remove the shift control cable from the transaxle range switch lever.
    Fig 1: Identifying Automatic Transmission Cable & Selector Lever
    GM893831Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connectors from the transaxle range switch.
  4. Remove the transaxle range switch lever nut and lever.
    Fig 2: Removing/Installing Transaxle Range Switch Lever & Nut
    GM893829Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle range switch bolts and remove the switch.
    Fig 3: Locating Transaxle Range Switch Bolts
    GM893832Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals