LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Park/Neutral Position (PNP) Switch Replacement >> Installation Procedure (New Switch)

Installation Procedure (New Switch)

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the transaxle manual shaft is in the Neutral position.
  2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the transaxle range switch bolts.

    Tighten:  Tighten the range switch bolts to 20 N.m (15 lb ft).

    Fig 1: Locating Transaxle Range Switch Bolts
    GM893832Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle range switch lever and nut.

    Tighten:  Tighten the transaxle range switch lever retaining nut to 35 N.m (26 lb ft).

    Fig 2: Removing/Installing Transaxle Range Switch Lever & Nut
    GM893829Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
  5. Install the shift control cable to transaxle range switch lever and verify proper operation.
    Fig 3: Identifying Automatic Transmission Cable & Selector Lever
    GM893831Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals