LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Output Axle Shaft Sleeve and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
  3. Remove the snap ring from axle.
    Fig 1: Locating Drive Axle Retaining Clip
    GM569164Courtesy of GENERAL MOTORS CORP.
  4. Remove the stub axle seal.
    Fig 2: View Of Case Cover Seal
    GM569151Courtesy of GENERAL MOTORS CORP.
  5. Use the J 41227  to remove the sleeve from the stub axle.
    Fig 3: Using Special Tool To Remove Sleeve From Output Axle Shaft
    GM569234Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals