LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.
  2. Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.
    Fig 1: Locating Oil Pan Gasket
    GM104471Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pan. Replace the bottom pan if damaged.
    Fig 2: View of Oil Pan
    GM104468Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the oil pan attaching bolts.

    Tighten:  Tighten the bolts to 14 N.m (124 lb in).

    Fig 3: Identifying Oil Pan Bolts
    GM104466Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
  6. Fill the transmission.
  7. Inspect the transmission fluid level. Refer to Transmission Fluid Checking Procedure.
  8. Inspect the oil pan gasket for leaks.
scientia non olet · About LEMON Manuals