LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Oil Feed Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the eight lo and the reverse band oil pipe assembly seals.
    Fig 1: Identifying Lo & Reverse Band Oil Pipe Assembly Seals
    GM104551Courtesy of GENERAL MOTORS CORP.
  2. Install the lo and the reverse band oil feed pipe assembly onto the transmission.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Hand start the bolts that attach the oil feed pipe assembly to the transmission.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    Fig 2: View Of Oil Feed Pipe Bolts
    GM104550Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission oil filter assembly. Refer to Oil Filter and Seal Replacement .
scientia non olet · About LEMON Manuals