LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Intermediate/Fourth Servo Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the intermediate/4th servo assembly. Refer to AUTOMATIC TRANSAXLE - 4T40-E/4T45-E - INTRODUCTION & OVERHAUL .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intermediate/4th band servo piston spring, the servo and the servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    Fig 1: View Of Intermediate/Fourth Servo Assembly & Bolts
    GM589165Courtesy of GENERAL MOTORS CORP.
  3. Install the oil feed pipes. Refer to Oil Feed Pipes Replacement .
  4. Install the filter and the pan. Refer to Oil Filter and Seal Replacement .
  5. Lower the vehicle.
  6. Fill the transmission with Dexron® III fluid.
  7. Inspect the transmission oil level. Refer to Transmission Fluid Checking Procedure
scientia non olet · About LEMON Manuals