LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the automatic transmission control lever handle retainer.
    Fig 1: Identifying Automatic Transmission Control Lever Handle Retainer
    GM104490Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic transmission control lever handle.
  4. Remove the console. Refer to Console Replacement - Front Floor in Instrument Panel, Gauges and Console.
  5. Remove the range select lever cable from the automatic transmission control.
    Fig 2: View Of Range Select Lever Cable
    GM104480Courtesy of GENERAL MOTORS CORP.
  6. Position aside the park lock cable. Refer to Park Lock Cable Replacement. 
  7. Remove the electrical connector.
  8. Remove the automatic transmission control nuts.
    Fig 3: Locating Automatic Transmission Control Nuts
    GM104495Courtesy of GENERAL MOTORS CORP.
  9. Remove the automatic transmission control.
scientia non olet · About LEMON Manuals