LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Automatic Transaxle - 4T40-E/4T45-E - Introduction, Service & Replacement) >> Repair Instructions >> Floor Shift Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the automatic transmission control.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the automatic transmission control nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    Fig 1: Locating Automatic Transmission Control Nuts
    GM104495Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector.
  4. Install the park lock cable. Refer to Park Lock Cable Replacement. 
  5. Install the range select lever cable to the automatic transmission control.
    Fig 2: View Of Range Select Lever Cable
    GM104480Courtesy of GENERAL MOTORS CORP.
  6. Install the console. Refer to Console Replacement - Front Floor in Instrument Panel, Gauges and Console.
  7. Install the automatic transmission control lever handle.
  8. Instal the automatic transmission control lever handle retainer.
    Fig 3: Identifying Automatic Transmission Control Lever Handle Retainer
    GM104490Courtesy of GENERAL MOTORS CORP.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals