Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air inlet duct.
Disconnect the shift cable from the PNP switch.
- Remove the shift cable lever.
- Remove the PNP switch. Refer to Park/Neutral Position (PNP) Switch Replacement .
- Install the engine support fixture.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the left inner fender liner. Refer to Front Fender Liner Replacement in Body Front End.
- Separate the left ball joint from the steering knuckle. Refer to Lower Ball Joint Replacement in Front Suspension.
- Remove the wheel drive shaft from the transmission. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
- Remove the power steering gear intermediate shaft pinch bolt.
- Remove the left front suspension cross member bolts. Refer to Crossmember Replacement in Frame and Underbody.
- Loosen the right front suspension cross member bolts.
- Remove the transmission mount. Refer to Automatic Transmission Mount Replacement in Transmission/Transaxle.
- Lower the vehicle.
- Lower the engine with the engine support fixture.
- Raise the vehicle.
- Remove the transmission side cover bolts.
- Remove the transmission side cover.