Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new O-ring seal. Refer to O-Ring Replacement .NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the service fitting to the compressor hose assembly.
Tighten: Tighten the serviceport to 12 N.m (106 lb in).
- Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the component using the J 39400-A .