LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Heating, Ventilation And Air Conditioning - Gas) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower motor resistor assembly.
    Fig 1: Identifying Blower Motor Resistor Assembly Screws
    GM477123Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the blower motor resistor assembly screws.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

  3. Connect the electrical connector to the blower motor resistor assembly.
    Fig 2: View Of Blower Motor Resistor Assembly Electrical Connector
    GM588308Courtesy of GENERAL MOTORS CORP.
  4. Install the blower motor. Refer to Blower Motor Replacement .
scientia non olet · About LEMON Manuals