LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Heating, Ventilation And Air Conditioning - Gas) >> Repair Instructions >> Accumulator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new O-rings on both ends of the accumulator tube. Refer to O-Ring Replacement .
  2. Install the accumulator tube to the accumulator and the evaporator core.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the accumulator tube fitting nuts.

    Tighten:  Tighten the nuts to 35 N.m (26 lb ft).

    Fig 1: Exploded View Of Accumulator Tube
    GM302602Courtesy of GENERAL MOTORS CORP.
  4. Reposition the cruise control module.
  5. Position the bracket holding the PCM module on to the shock tower.
  6. Install the bracket nuts holding the PCM module on to the shock tower.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  7. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  8. Leak test the fittings of the component using the J 39400-A.
scientia non olet · About LEMON Manuals