LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Heating, Ventilation And Air Conditioning - Gas) >> Repair Instructions >> Accumulator Replacement (L61) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Add the required amount of new refrigerant oil. Refer to Refrigerant System Capacities (L61) .
  1. Install the accumulator (1).
    Fig 1: Exploded View Of Accumulator Tube
    GM302602Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the accumulator bracket (3) clamp.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in).

  3. Install new O-ring seals to refrigerant lines.
  4. Install the refrigerant lines to the accumulator.
  5. Install the accumulator tube to accumulator and compressor tube to accumulator fitting nuts.

    Tighten:  Tighten nuts to 35 N.m (26 lb ft).

  6. Position the bracket holding the PCM module on to the shock tower.
  7. Install the bracket nuts holding the PCM module on to the shock tower.

    Tighten:  Tighten the PCM bracket nuts to 10 N.m (89 lb in).

  8. Reposition the cruise control bracket if equipped.
  9. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  10. Leak test the fittings of the component using the J 39400-A  .