Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Remove any twists in the seat belt webbing before final assembly.

Insert the top of the seat belt retractor into the T-slot.
Push down the top of the retractor to engage the retractor with the T-slot in the center pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the seat belt retractor bolt (3).
Tighten: Tighten the bolt to 48 N.m (35 lb ft).
Install the seat belt intermediate guide rivet (2).
With a rivet gun, secure the rivet (2) to the intermediate guide.

Fig 1: Exploded View Of Front Seat Belt Retractor (Coupe)
Courtesy of GENERAL MOTORS CORP.
Install the rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter in Interior Trim.
Install the shoulder belt guide bolt (1).
Tighten: Tighten the bolt to 41 N.m (30 lb ft).
Push down on the shoulder belt guide cover (5) until fully seated.
Install the seat belt anchor bolt (4).
Tighten: Tighten the bolt to 48 N.m (35 lb ft).

Inspect the seat belt retractor for proper operation. Refer to Operational and Functional Checks .