LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Center Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. From inside the vehicle install the rear seat belt retractor assembly (1) to the rear shelf (2).
  2. From the rear compartment slide the retractor rearward to engage the locking tab (4) into the retractor bracket (5).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the rear seat belt retractor bolt (3).

    Tighten:  Tighten the bolt to 28 N.m (21 lb ft).

    Fig 1: View Of Center Rear Seat Belt Retractor
    GM873910Courtesy of GENERAL MOTORS CORP.
  4. Install the rear window panel trim. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
  5. Check the rear seat retractor belt for proper operation.
scientia non olet · About LEMON Manuals