LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Power Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tie rod end (3) to the inner tie rod shaft (1).
  2. Install the outer tie rod ball stud (4) to the steering knuckle (6).
    Fig 1: View Of Outer Tie Rods And Steering Knuckles
    GM441937Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the new prevailing torque nut (5) to the outer tie rod ball stud (4).

    Tighten:  Tighten the new prevailing torque nut to 45 N.m (33 lb ft).

  4. Install the front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Adjust the front toe. Refer to Front Toe Adjustment in Wheel Alignment.
scientia non olet · About LEMON Manuals