LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement (2.2L (L61)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to INSTALLING HOSES WITHOUT TWISTS OR BENDS NOTICE in Cautions and Notices.
  1. Install the power steering pressure hose (3) to the vehicle.
    Fig 1: View Of Power Steering Pressure Hose & Fittings
    GM490384Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the power steering pressure hose (3) to the power steering pressure pipe (4).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  3. Install the upper air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls-2.2L (L61).
  4. Raise the vehicle.
  5. Install the front exhaust pipe, automatic transmission only. Refer to Intermediate Pipe Replacement in Engine Exhaust.
  6. Connect the power steering pressure hose (1) to the power steering gear (3).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

    Fig 2: View Of Power Steering Pressure Hose
    GM639559Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals