LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering pressure pipe (4) to the vehicle.
    Fig 1: Identifying Power Steering Pressure Pipe Bracket
    GM639567Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Connect the power steering pressure pipe (4) to the power steering pump (1).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  3. Install the bolt (2) to the power steering pressure pipe bracket (3).

    Tighten:  Tighten the bolt to 26 N.m (19 lb ft).

  4. Connect the power steering pressure hose (3) to the power steering pressure pipe (4).

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

    Fig 2: View Of Power Steering Pressure Hose & Fittings
    GM490384Courtesy of GENERAL MOTORS CORP.
  5. Bleed the power steering system. Refer to Bleeding the Power Steering System .
scientia non olet · About LEMON Manuals