Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine mount to the vehicle.
Align the engine mount (2) to the mount bracket using a dowel (1).

Fig 1: Aligning Engine Mount
Courtesy of GENERAL MOTORS CORP.
Hand tighten the engine mount to body nuts (1).

Fig 2: View Of Engine Mount To Body Nuts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the engine mount (2) to bracket bolts (1).

Fig 3: View Of Engine Mount To Bracket Bolts
Courtesy of GENERAL MOTORS CORP.

Tighten:
- Tighten the engine mount to body nuts to 66 N.m (49 lb ft).
- Tighten the engine mount to bracket bolts to 130 N.m (96 lb ft) plus 45 degrees.
Install the A/C low pressure line retaining bracket (1) nut. Refer to Compressor Hose Assembly Replacement (L61) in Heating, Ventilation and Air Conditioning.

Fig 4: View Of A/C Low Pressure Line Retaining Bracket
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the nut to 10 N.m (89 lb in).
Install the cruise control module. Refer to Cruise Control Module Replacement in Cruise Control.
Remove the floor jack.