LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner.
    Fig 1: View Of Drive Belt Tensioner
    GM758258Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: In order to obtain the proper torque when using any torque wrench adapter you must use the following formula: Pre-set Torque = Torque Wrench Length x Torque Desired divided by Torque Wrench Length + Extension Length.
  2. Install the drive belt tensioner bolt.

    Use a J 45025  to tighten the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 45 N.m (33 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals