LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft balancer.
    Fig 1: View Of Crankshaft Balancer
    GM412138Courtesy of GENERAL MOTORS CORP.
  2. Install a NEW crankshaft balancer bolt.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Use J 38122-A  to prevent the crankshaft from rotating while tightening the crankshaft balancer bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft) plus 75 degrees.

    Fig 2: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
  4. Install the engine drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals