Engine Flywheel Installation

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38122-A: Harmonic Balancer Holder. See Special Tools and Equipment .
J 45059: Angle Meter. See Special Tools and Equipment .

Install the flywheel.

Fig 1: View Of Flywheel
Courtesy of GENERAL MOTORS CORP.
Install the NEW bolts.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Holding the crankshaft damper with the J 38122-A , tighten the bolts evenly.
Tighten: Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the J 45059 .