LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker panel molding to the rocker.
  2. Press the rocker panel molding to the rocker until the retainers are fully seated.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Installing Rocker Panel Molding Screws
    GM827677Courtesy of GENERAL MOTORS CORP.
  3. Install the rocker panel molding screws.

    Tighten:  Tighten the rocker panel molding screws to 2 N.m (18 lb in).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals