LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Quarter >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. When replacing a body side molding do the following:
    1. Use tape to protect the mounting surface during removal.
    2. Use tape for alignment marks for installation of the body side molding (1).
      3. Fig 1: Aligning Rear Quarter Body Side Molding
      GM740892Courtesy of GENERAL MOTORS CORP.
  2. To remove a body side molding, heat the body side molding using a J 25070  . See Special Tools and Equipment .
  3. Hold the J 25070  approximately 152 mm (6 in) from the surface. See Special Tools and Equipment .
  4. Apply heat using a circular motion for about 30 seconds.
  5. Remove the molding from the rear quarter panel.
scientia non olet · About LEMON Manuals