LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Quarter >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Apply the molding in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
  1. Clean the area where the molding will be installed.

    Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a, 50/50 mixture, by volume of isopropyl alcohol and water to clean the area.

  2. Dry the area thoroughly.
    3. IMPORTANT: Do not touch the adhesive backing on the molding.
  3. Remove the protective liner from the back of the body side molding.
  4. If the location of the molding has not been marked, apply tape and use the following dimensions:
    • Starting at the front of the quarter panel, the distance from the rocker panel trim to the molding is 191 mm (6.750 in).
    • At the rear of the quarter panel, the distance from the rocker panel trim to the molding is 203 mm (8.0 in).
      • Fig 1: Aligning Rear Quarter Body Side Molding
      GM740892Courtesy of GENERAL MOTORS CORP.
  5. Ensure that the temperature of the molding is approximately 29-32°C (85-90°F).
  6. Position the body side molding to the location marks and press the molding to the mounting surface.
  7. Apply equal pressure along the molding to uniformly bond the molding to the mounting surface.
  8. Remove the protective tape from the mounting surface.
scientia non olet · About LEMON Manuals