LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Wiper System & Washer System) >> Repair Instructions >> Wiper Transmission Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper transmission to the wiper drive system module tube frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the wiper transmission screws.

    Tighten:  Tighten the screws to 9 N.m (79 lb in).

    Fig 1: Installing Wiper Transmission Screws
    GM347712Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper transmission caps.
  4. Apply grease to the motor crank arm pivot.
  5. Using theJ 39529  , connect the wiper transmission to the wiper motor crank arm. See Special Tools and Equipment .
    6. Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  6. Position the wiper drive system module to the vehicle.
  7. Install the wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    Fig 3: Installing Wiper Drive System Module Screws
    GM347709Courtesy of GENERAL MOTORS CORP.
  8. Connect the wiper motor electrical connector.
  9. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  10. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals