LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper motor to the wiper drive system module.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    Fig 1: Installing Wiper Motor Screws
    GM347710Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The motor crank arm pivot is a greased joint to the wiper transmission.
  3. Apply grease to the motor crank arm pivot.
  4. Using J 39529  , connect the wiper transmission arms to the wiper motor crank arm.
    5. Fig 2: Installing Wiper Transmission To Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  5. Position the wiper drive system module to the vehicle.
  6. Install the wiper drive system module screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    Fig 3: Installing Wiper Drive System Module Screws
    GM1200401Courtesy of GENERAL MOTORS CORP.
  7. Connect the wiper motor electrical connector.
  8. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  9. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals