LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply RTV Sealer in the seal channel of the wiper motor cover.
    Fig 1: Identifying Wiper Motor Cover Seal Channel
    GM1194807Courtesy of GENERAL MOTORS CORP.
  2. Position the wiper motor cover onto the wiper motor.
  3. Connect the wiper motor electrical connector.
    Fig 2: Connecting Wiper Motor Electrical Connector
    GM1194806Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the wiper motor cover screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Inspect the wipers for proper operation.
scientia non olet · About LEMON Manuals