LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the air induction tube to the washer solvent container.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the air induction tube screw.

    Tighten:  Tighten the screw to 3 N.m (27 lb in).

    Fig 1: Installing Air Induction Tube Screw
    GM639598Courtesy of GENERAL MOTORS CORP.
  3. Position the washer solvent container to the vehicle.
  4. Install the washer solvent container screws.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    Fig 2: Installing Washer Solvent Container Screws
    GM639597Courtesy of GENERAL MOTORS CORP.
  5. Install the push-in retainer to the air induction tube.
  6. Connect the washer pump hose.
  7. Connect the washer pump electrical connector.
    Fig 3: Connecting Washer Pump Electrical Connector
    GM452363Courtesy of GENERAL MOTORS CORP.
  8. Connect the anti-lock brake electrical harness to the washer solvent container.
    Fig 4: Installing Anti-Lock Brake Electrical Harness
    GM827811Courtesy of GENERAL MOTORS CORP.
  9. Install the front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  10. Lower the vehicle.
  11. Install the washer solvent container cap.
  12. Fill the washer solvent container with solvent.
  13. Inspect the washer system for proper operation.
scientia non olet · About LEMON Manuals