Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear fascia brackets into the rear fascia.

Fig 1: Installing Rear Fascia Brackets (Chevrolet)
Courtesy of GENERAL MOTORS CORP.
Install the rear license plate lamp socket and bulb. Refer to License Lamp Replacement (Sedan and Coupe) or License Lamp Replacement (Sunfire GT) in Lighting Systems.
Install the electrical connector to the rear fascia.
Perform the following steps to install the rear fascia:
1. Align the rear fascia to the center of the rear impact bar.
2. With the aid of an assistant, fit both corners of the rear fascia to the quarter panel.
Install the push pin fasteners to the lower center tabs of the rear fascia.

Fig 2: Installing Rear Fascia Push Pin Fasteners (Chevrolet)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Fig 3: Installing Rear Fascia Screws (Chevrolet)

Courtesy of GENERAL MOTORS CORP.

Install the screws to the rear fascia in the rear wheel opening.
Tighten: Tighten the screws to 3 N.m (27 lb in).
Lower the vehicle.
Install the screws that attach the rear fascia to the quarter panel.
Tighten: Tighten the screws to 3 N.m (27 lb in).
Install the rear compartment trim as required. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
Close the rear compartment lid.