LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the accelerator cable from the accelerator pedal. Refer to Accelerator Controls Cable Replacement in Engine Controls - 2.2L (L61).
  2. Remove the retaining clip (1) and outer washer (2) from the brake pedal.
  3. Disconnect the brake booster pushrod (3) from the brake pedal.
  4. Remove the inner washer (4) from the brake pedal.
    Fig 1: Exploded View Of Brake Pedal Assembly
    GM1311217Courtesy of GENERAL MOTORS CORP.
  5. Remove the stop lamp switch from the brake pedal assembly. Refer to Stop Lamp Switch Replacement in Lighting Systems.
  6. Remove the cruise control release switch, if equipped, from the brake pedal assembly. Refer to Clutch Pedal Cruise Control Release Switch Replacement in Cruise Control.
  7. Release the electrical harness from the brake pedal assembly.
  8. Remove the brake booster mounting nuts (2).
    Fig 2: Removing Brake Booster Mounting Nuts
    GM188320Courtesy of GENERAL MOTORS CORP.
  9. Remove the brake pedal assembly upper mounting nut.
  10. Remove the brake pedal assembly (1) from the vehicle.
scientia non olet · About LEMON Manuals