LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake hose (3) to the brake hose mounting brackets.

    Align the hose fitting with the notch in the bracket. Use the hose paint stripe as a visual aid.

  2. Install the hose retaining clips (1) and (2) onto the hose fittings at the hose brackets.
    Fig 1: View Of Brake Hose Mounting Brackets
    GM492719Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Using a backup wrench on the hose fitting, connect the brake pipe fittings at the rear brake hose.

    Tighten:  Tighten the fittings to 23 N.m (17 lb ft).

  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
  6. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals