Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
- The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
DTC B0005
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Brake Warning System Schematics Connector End View Reference: Hydraulic Brakes Connector End Views |
|||
| 1 | Did you perform the Hydraulic Brake Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Hydraulic Brakes |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Test the signal circuit of the park brake switch for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 5 | Replace the park brake switch. Refer to Park Brake Warning Lamp Switch Replacement
. Did you complete the repair? |
Go to Step 7 | - |
| 6 | Replace the BCM. Refer to Body Control Module Replacement
in Body Control System. Did you complete the repair? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |