LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Cushion Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system, if equipped with side impact inflatable restraints. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
  2. Remove the front bucket seat. Refer to Seat Replacement .
  3. Remove the seat cushion outer trim panel screws.
  4. Remove the seat cushion outer trim panel from the recliner.
  5. With a flat-bladed tool remove the lumbar knob from the actuator, if equipped.
  6. Remove the lumbar actuator from the cushion frame, if equipped. Refer to Lumbar Replacement - Front Seat (Pontiac) .
  7. Unfasten the lumbar actuator cable from the cushion frame, if equipped.
  8. Unfasten the wire harness for the Side Impact Air Bag (SIAB) from the cushion frame, if equipped.
  9. Remove the seat back recliner bolts (6).
  10. Remove the seat back pivot bolt (3).
  11. Remove the seat back (1) from the seat cushion (5).
    Fig 1: Removing Seat Back Recliner Bolts
    GM278885Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals