LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Cushion Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back (1) to the seat cushion (5).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat back pivot bolt (3).

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

  3. Install the seat recliner bolts (6).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    Fig 1: Installing Seat Back Recliner Bolts
    GM278885Courtesy of GENERAL MOTORS CORP.
  4. Fasten the wire harness for the SIAB to the cushion frame, if equipped.
  5. Fasten the lumbar actuator cable to the cushion frame, if equipped.
  6. Install the lumbar actuator to the cushion frame, if equipped. Refer to Lumbar Replacement - Front Seat (Pontiac) .
  7. Align the lumbar knob to the splines on the actuator, if equipped.

    Press onto the actuator until fully engaged.

  8. Install the seat cushion outer trim panel to the recliner.
  9. Install the seat cushion outer trim panel screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  10. Install the bucket seat. Refer to Seat Replacement .
  11. Enable the SIR system, if equipped with side impact inflatable restraints. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals