LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Cushion Frame Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion cover (2) to the seat cushion frame (1).
  2. Fasten the J-hook retainers (3) to the seat cushion frame (1).
  3. On the driver side install the seat belt buckle (6) to the cushion frame (1).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the seat belt buckle bolt.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

    Fig 1: Installing Seat Belt Buckle Bolt
    GM896599Courtesy of GENERAL MOTORS CORP.
  5. Install the seat adjusters to the seat frame. Refer to Seat Adjuster Replacement - Front (Driver)  or Seat Adjuster Replacement - Front (Passenger) .
  6. Install the seat cushion to the seat back. Refer to Seat Cushion Replacement - Front .
  7. Enable the SIR system, if equipped with SIAB. Refer to SIR Disabling and Enabling Zone 7 or SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals