LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Replacement - Rear Split Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat back into the vehicle.

    Left side shown.

  2. Align the opening on the seat back bottom to the center pivot pin (1) on the latch assembly.
  3. Slide the outboard side of the seat back (2) towards the outside of the vehicle. This will install the seat back (1) to the center pivot pin on the latch assembly.
    4. Fig 1: Installing Seat Back - Rear Split Folding
    GM875656Courtesy of GENERAL MOTORS CORP.
  4. Align the shoulder bolt (3) to the retainer (2) on the latch assembly (4).
  5. Push the down on the seat back (1). This will engage the shoulder bolt (3) to the retainer (2) on the latch assembly (4).
  6. Return the seat back (1) to the original position.
  7. Close the rear compartment lid.
    Fig 2: Installing Shoulder Bolt Retainer - Rear Split Folding
    GM834210Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals