LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Release Latch Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back latch to the rear package self.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat back latch bolts to the latch.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    Fig 1: Installing Seat Back Latch Bolts - Rear
    GM801151Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back release handles to the rear package shelf.

    Press the seat back release handles into the rear package shelf until fully seated.

  4. Install the GSP sensor to the rear shelf, if equipped. Refer to Navigation Antenna Replacement .
    Fig 2: Installing GSP Sensor - Rear
    GM740619Courtesy of GENERAL MOTORS CORP.
  5. Install the rear window panel trim. Refer to Trim Panel Replacement - Rear Window Shelf in Interior Trim.
  6. Close the rear compartment lid.
  7. Check the seat back latch for proper operations.
scientia non olet · About LEMON Manuals