LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Cavalier LS, 2.2 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Front (AR9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Sunfire and 2004 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recliner to the seat.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the recliner bolts (1,2)

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Install the seat back pad and cover to a desired appearance.
  4. Fasten the J-hook retainer located next to the SIAB module, if equipped.
  5. Fasten the J-hook retainer located at the bottom of the seat back cover.
    Fig 1: Installing Seat Back Recliner - Front (AR9)
    GM279088Courtesy of GENERAL MOTORS CORP.
  6. Install the outer trim panel on the seat cushion. Refer to Seat Cushion Outer Trim Panel Replacement .
  7. Install the bucket seat. Refer to Seat Replacement .
  8. Reposition the seat back to the original position.
  9. Check the seat back recliner for proper operation.
  10. Enable the SIR system, if equipped with SIAB. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals